Flavel Windsor - Page 23

Supplied By www.heating spares.co Tel. 0161 620 6677
g) Position the piece of driftwood with the letter “F” stamped onto the
bottom face of it in the across the centre of the driftwood pieces “A”,
“B” & “C”. Ensure this piece of driftwood is located into the groove’s on
the top face of driftwood pieces A, B & C . See Fig. 22 below.
Fig. 22
h) Position the piece of driftwood with the letter “G” stamped onto the
bottom face of it in the across the left hand side of the fuelbed matrix,
locating into the grooves on driftwood pieces “A” & “B”. See Fig. 23
below.
Fig. 23
23
Driftwood Piece “F”
Locating grooves
for driftwood piece
“F” in centre of
driftwood piece “A”,
“B” & “C”
Driftwood Piece “G”
Locating grooves
for driftwood piece
“G” in top of drift-
wood piece “A” &
“B”