BB r r i i nn ee FF i i t t t t i i nn gg
BB r r i i nn ee L L i i nn ee FF i i t t t t i i nn gg s s
between the $oat and the brine well to secure the over$ow nut you can remove the $oat by removing
the nut that holds the $oat in place. Make sure to put it back when you are #nished.
UU s s e e 3 3 / / 8 8 i i nn c c h h l l i i n n e e t t oo c c oo n n n n e e c c t t bb r r i i nn e e t t a a nn k k t t oo c c oo nn t t r r oo l l hh e e a a dd
The brine line will connect from
the brine #tting on the control
the $oat inside the brine tank.
To attach it to the $oat put the
tubing through the hole in the
brine tank and push the tubing
into the #tting until in stops,
then push a little harder to get it
to lock in place. To remove the
tubing, hold the collet ring that
sits around the tubing while
pulling the tubing out. The other end of the tubing will connect to the control head. Place the #ttings on
—and connect it to the control head.
CC oo nn nn ee c c t t oo v v ee r r $$ oo ww t t oo $$ oo oo r r dd r r aa i i nn
OO p p t t i i o o n n a a l l
If you have a $oor drain available you can connect the over$ow #tting to it using a $exible line.
nn oo t t cc oo nn nn ee cc t t t t hh ee oo vv ee r r $$ oo ww t t oo t t hh ee dd r r aa i i nn l l i i nn ee f f r r oo mm t t hh ee cc oo nn t t r r oo l l hh ee aa dd oo r r r r uu nn t t hh ee l l i i nn ee aa bb oo vv ee tt hh ee ll ee vv ee ll oo ff
tt hh ee oo v v ee rr $$ oo ww oo uu tt l l ee tt . .
AA dd dd s s a a l l t t t t oo t t hh ee bb r r i i nn ee t t a a nn k k , ,
ww a a t t e e r r i i s s n n o o t t n n e e c c e e s s s s a a r r y y
Add salt to the brine tank. We recommend high quality pelleted softener salt for the best results. You
will need to add at least one bag of salt and can #ll it up to the top of the brine well. Ensure there is salt
in the brine tank at all times.
YY oo uu dd oo NN OO TT nn ee ee dd t t oo aa dd dd ww aa t t ee r r t t oo t t hh ee bb r r i i nn ee t t aa nn kk . .
precharged and able to treat the water out of the box and the initial regeneration ran after installing
the system will place the initial volume of water in the brine tank.
SS EE TT UU PP CC OO NN T T R R OO L L HH EE AA DD
PP l l uu gg c c oo nn t t r r oo l l hh ee aa dd i i nn
Plug the control head into a quali#ng outlet as stated in the requirements section.
PP l l ee aa s s ee NN oo t t ee : :
The contol head can be plugged in and operated without water, this will not damage the control head.
Once plugged in, verify the system is receiving power and ensure the outlet is not on a switch that
might get turned o!. On digital valves the display should light up and start $ashing a time, on
9 of 19
To Next Page
Loading...
