PAG E 11Help: 888-426-5001 QualityWaterForLess.com
bacK . fIGure 11-afront
fIGure 11-c
5) Loosen the screws holding the plumbing adaptor
clips in place as shown in Figure 11-A and locate
the plumbing adapter that came with your system
6) Using the included silicone lubricant packet,
lubricate the o-rings on the meter of the Fleck
9000 Meter Valve as shown in Figure 11-B
fIGure 11-d
bacK . fIGure 11-ffront
fIGure 11-e
7) Attach the plumbing adaptor to the valve as
shown in Figure 11-C (your bypass/plumbing
adapter model may vary). When assembling
the clips back onto the valve, leave the first clip
loose, tighten the second clip, and complete
the assembly by going back and tightening the
first clip.
i
Please lightly tighten the screws
into the meter as overtightening will easily
cause cracking
8) Lubricate all four tube assembly adapters as
shown in Figure 11-D and insert two into each end
of the tube assembly
9) First, locate the tube assembly clips and attach
the tube assembly to the second tank adapter as
shown in Figure 11-E
10) Then attach the plastic tube assembly onto the
Fleck 9000 Meter Valve as shown in Figure 11-E
(you will need to swing open the program panel to
access and tighten the hidden tube assembly clip)
fIGure 11-b
To Next Page
Loading...
