PAGE 8 QualityWaterForLess.com Help: 888-426-5001
› Pre-InstallatIon
Before assembly of your new system, be sure that the following conditions have been met for the place-
ment of your system:
• Level, firm surface, such as concrete, on which
to place the softener tanks and salt tank (also
known as a
brine
tank)
• Un-switched power source, standard US plug,
120v 60hz (the softener system includes a
5 ft power cord and plug)
• Access to the water main coming into your
home. You will need to install the softener at
this point to assure that water for the home is
going through the system
• Nearby floor drain or standpipe to connect to the
softener for use during each regeneration
Well
Pump or
City
Meter
Water
Heater
Bypass
Bath Sink Toilet Kitchen
SpigotSpigot
Softener
Drain Line
Hard Water
Soft Water
Overflow
(Optional)
Floor
Drain
To Next Page
Loading...
