Flexim FLUXUS ADM 7 07 Series User Manual

SU_ModbusV2-8, 2015-03-02
SU_ModbusV2-8
Ergänzung zur Bedienungsanleitung - DEUTSCH
Modbus-Server
Supplement to User Manual - ENGLISH
Modbus Server
FLUXUS ADM 5x07 (Sonderausführung)
FLUXUS ADM 7x07, G70x, F705
FLUXUS ADM 8x27, F808, G80x
FLUXUS ADM 8x27P, G80xP
(mit passivem Stromausgang)
PIOX TS37x
PIOX S705

Flexim FLUXUS ADM 7 07 Series Specifications

General

Brand	Flexim
Model	FLUXUS ADM 7 07 Series
Category	Measuring Instruments
Language	English

Summary

Introduction to Modbus Server

Modbus and RS485 Sender Modes

Explains the two operational modes for the transmitter: Modbus slave and RS485 sender.

Transmitter Configuration

HotCode Entry and Mode Selection

Procedure for entering HotCode and selecting the operating mode (sender/Modbus).

Transmission Parameter Setup

Configuration of baud rate, parity, and stop bits for data transmission.

Modbus Data Transmission

Modbus RTU Telegram Structure

Modbus Function Codes

Modbus Register Addressing

Addresses for Physical Quantities

Lists Modbus register addresses for common physical quantities measured by the transmitter.

Register Address Ranges for Measurement Data

Overview of address ranges for different types of measurement data.

Modbus Data Request Methods

Single Value Request

How to request individual physical quantities or diagnostic values using offsets.

Multiple Value Requests

Additional Data and HPI

Special Registers and Parameters

Firmware, Heartbeat, and Response Delay

Special Functions

CRT Functionality Overview

Introduction to the Customer Register Table (CRT) for custom register mapping.

Totalizer Management