Flexim FLUXUS F601 - User Manual

Page 1 of 5
Simplified Installation of the FLUXUS F601 Ultrasonic Flowmeter
These few pages will guarantee your success. If you decide to install the F601 without
our free telephone support, please follow these steps closely. If you have ANY
questions, don’t waste your valuable time; give us a call; we can answer your questions
in seconds.
Call us Toll Free at 866-337-4356
F601 Keyboard Functions
• Switch the transmitter ON by pressing the “C” key
• Make Vertical selections by pressing the “2” or “8” keys
• Make Horizontal selections by pressing the “4” or “6” keys
• Return to the Main Menu by pressing the “BRK” key
• To Delete any entry, press the “C” key
• Switch the F601 OFF by pressing the “BRK” key 3 times
Choose the Appropriate Installation Site
Place your F601 within transducer cable distance of your
measurement site, or use a transducer extension cable as needed.
If you are unsure about choosing the exact mounting site on your
unique pipes, please refer to a FlowRental document titled
“Selecting a Transducer Installation Site” appended to these
instructions.
Connect your Transducers to the F601
The red point on the connector must align with the red marking on
the socket. Remove the connector by pulling at the knurled surface.
Please connect your transducers before beginning the programming
below.
Follow these Steps to Program your F601
Programming your F601 will require 3 simple steps:
• Install Pipe and Fluid PARAMETERS
• Program the OUTPUT Options
• Enter the MEASURING mode and begin your measurements

Summary

F601 Keyboard Functions

Installation Site and Transducer Connection

Choose the Appropriate Installation Site

Guide to selecting the correct location for the F601 and transducer.

Connect your Transducers to the F601

Instructions on how to properly connect the transducers to the F601 unit.

Entering PARAMETERS

Select Channel and Enter Parameters

Navigate menus and input pipe and fluid parameters like diameter, material, and temperature.

Entering Output Options

Configure Flow Measurement and Data Output

Set flow type, units, data storage, and serial output preferences.

Entering the MEASURING Mode

Activate Measurement Channel and Set Sound Path

Activate the measurement channel, assign point numbers, and configure sound path and transducer distance.

Mounting the Transducers

Secure Transducers and Verify Signal Strength

Mount transducers securely, ensure good signal strength, and view real-time flow rate.

Flexim FLUXUS F601 Specifications

General

Brand	Flexim
Model	FLUXUS F601
Category	Measuring Instruments
Language	English