Need help?Do you have a question about the Flexim FLUXUS WW and is the answer not in the manual?
General| Flow Velocity Range | 0.01 to 25 m/s (0.03 to 82 ft/s) |
|---|---|
| Fluid Types | Liquids |
| Pipe Size Range | DN 15 to DN 6500 (0.5" to 256") |
| Temperature Range | -40°C to 200°C (-40°F to 392°F) (depending on transducer) |
| Protection Class | IP65 |
| Power Supply | 100-240 VAC, 24 VDC |
| Outputs | 4-20 mA, Relay |
| Communication | HART, Modbus, Ethernet |
| Measurement Variables | Flow velocity |
| Pipe Diameter Range | DN 15 to DN 6500 (0.5" to 256") |
| Certifications | ATEX, IECEx, FM, CSA |
| Measuring Principle | Ultrasonic transit-time difference |
Highlights how safety instructions are marked in the manual.
Provides general safety guidelines, symbols, and warnings for operation.
Covers safety procedures for electrical connections and work on the transmitter.
Outlines safety precautions for authorized and trained personnel.
Explains requirements for acoustic penetration for signal transmission.
Specifies requirements for selecting measuring point and transmitter location considering ambient temperature.
Outlines steps to prepare the pipe surface for optimal acoustic contact.
Guides on correct transducer mounting orientation and distance setting.
Shows a diagram of the transmitter's terminals and their labels.
Lists required initial settings: language, units, and time/date.
Describes the process after connecting power, including serial number and default language display.
Covers entering essential pipe dimensions like diameter and wall thickness.
Explains inputting outer pipe diameter or circumference.
Details inputting pipe wall thickness and its effect on inner diameter calculation.
Details fine-tuning transducer distance using a bar graph for signal quality.
Guides on choosing measured quantities and their units.
Guides on setting up calculation channels by selecting inputs and functions.
Lists data stored by the logger and how to activate it.
Instructions for enabling or disabling the data logger functionality.
Explains transmitting data in real-time during measurement.
Details transmitting logged data from the device after measurement.
Specifics on transmitting logged data offline to a terminal.
Explains how to enter and exit SuperUser mode using HotCodes.
Addresses issues like no signal, incorrect parameters, and poor acoustic contact.
To Next Page