Flexim FLUXUS WW - Setting the Contrast; Instrument Information

FLUXUS WW 14 Settings
104 UMFLUXUS_WWV1-1EN, 2018-02-28
14.4 Setting the contrast
It is possible to reset the display to medium contrast. Press key C. Enter the HotCode 555000 (see section 9.5).
14.5 Instrument information
Select Special Funct.\SYSTEM settings\Miscellaneous to set the display con-
trast of the transmitter. Press ENTER.
The display contrast is adjusted with the following keys:
increases the contrast
reduces the contrast
= min. contrast
= medium contrast
= max. contrast
Note!
After an initialization of the transmitter, the display is reset to medium contrast.
Select Special Funct.\Instrum. Inform. to get information about the transmitter.
Press ENTER.
The type and the serial number of the transmitter are displayed in the upper line.
The available data logger will be displayed in the lower line (here: 18 327 additional mea-
sured values can be stored). For further information about the data logger, see section
13.1.6.
Press ENTER.
The type and the serial number of the transmitter are displayed in the upper line.
The firmware version of the transmitter is displayed with the date in the lower line.
Press ENTER.
SYSTEM settings↕
Miscellaneous
SETUP DISPLAY
← CONTRAST →
6
4
2
5
8
Special Funct. ↕
Instrum. Inform.
FLUXUS WW -XXXXXXXX 
Free: 18327
FLUXUS WW -XXXXXXXX 
V x.xx dd.mm.yy