9 Start-up of the transmitter FLUXUS WW
UMFLUXUS_WWV1-1EN, 2018-02-28 71
9.6 Language selection
The transmitter can be operated in the languages listed below. The language can be selected with the following Hot-
Codes:
Depending on the technical data of the transmitter, some of the languages might not be implemented.
When the last digit has been entered, the main menu is displayed in the selected language.
The selected language remains activated when the transmitter is switched off and on again. After an initialization of the
transmitter, the language is reset to the default language.
9.7 Interruption of the power supply
As soon as the measurement begins, all current measuring parameters will be stored in a non-volatile INIT-resistant
EPROM. In case of a power supply failure, the measurement will be stopped. All input data remain stored.
The interrupted measurement is continued. All selected output options are still active. If an initialization was carried out,
the measurement will not be continued after restoring the power supply.
Tab. 9.1: Language HotCodes
909031 Dutch
909033 French
909034 Spanish
909044 English
909049 German
After the power supply has returned, the serial number is displayed for a few seconds.
FLEXIM FLUXUS
FLUXUS
WW -XXXXXXXX
To Next Page
Loading...
Need help?
General
