FLUXUS WW 14 Settings
100 UMFLUXUS_WWV1-1EN, 2018-02-28
14 Settings
14.1 Time and date
The transmitter has a battery-powered clock. Measured values are automatically stored with date and time.
14.1.1 Time
14.1.2 Date
After the time has been set, DATE is displayed.
14.2 Dialogs and menus
14.2.1 Pipe circumference
Select Special Funct.\SYSTEM settings\Set Clock.
Press ENTER.
The current time is displayed. Select ok to confirm the time or new to adjust it. Press EN-
TER.
Select the character to be edited with key and .
Edit the selected character with key and .
Press ENTER.
The new time is displayed. Select ok to confirm the time or new to adjust it again. Press
ENTER.
Select ok to confirm the date or new to adjust it.
Press ENTER.
Select the character to be edited with key and .
Edit the selected character with key and . Press ENTER.
The new date is displayed. Select ok to confirm the date or new to adjust it again. Press
ENTER.
Select Special Funct.\SYSTEM settings\Dialogs/Menus. Press ENTER.
Note! The settings will be stored at the end of the dialog. If the menu item is quit by pressing key BRK, the
changes will not be stored.
Select on if the pipe circumference is to be entered instead of the pipe diameter in the pro-
gram branch Parameter. Press ENTER.
If on is selected for Pipe Circumfer., the outer pipe diameter will nevertheless be re-
quested in the program branch Parameter.
To select the menu item Pipe Circumfer., enter 0 (zero). Press ENTER.
The value displayed in Pipe Circumfer. is calculated on the basis of the last displayed
value of the outer pipe diameter.
Example: 100 mm
.
π = 314.2 mm
Enter the pipe circumference. The limits for the pipe circumference are calculated on the
basis of the limits for the outer pipe diameter.
SYSTEM settings↕
Set Clock
DATE 2011-01-25
Set Date !
SYSTEM settings↕
Dialogs/Menus
To Next Page
Loading...
Need help?
General
