3 Handling FLUXUS WW
UMFLUXUS_WWV1-1EN, 2018-02-28 13
3 Handling
3.1 First inspection
The transmitter has already been tested thoroughly at factory. At delivery, proceed to a visual control to make sure that no
damage has occurred during transportation.
Make sure that the specifications of the delivered transmitter correspond to the specifications given on the purchase order.
The type and the serial number of the transmitter are shown on the nameplate. The transducer type is printed on the trans-
ducers.
3.2 General precautions
FLUXUS is a precision measuring instrument and has to be handled with care. In order to obtain good measurement re-
sults and to avoid damaging the transmitter, it is important to pay special attention to the instructions given in this user
manual, particularly to the following points:
• Protect the transmitter from shocks.
• The housing may only be opened by authorized personnel. The degree of protection of the transmitter FLUXUS WW is
only ensured if the front plate is tightly screwed to the housing.
• Keep the transducers clean. Handle the cables with care. Avoid excessive cable bends.
• Make sure to work under correct ambient and operating temperatures. The ambient temperature at the measuring point
has to be within the operating temperature range of the transmitter and the transducers (see Technical specification).
• Observe the degree of protection (see Technical specification).
3.3 Cleaning
• Clean the transmitter with a soft cloth. Do not use detergents.
• Remove traces of the coupling compound from the transducers with a soft paper towel.
Attention! Observe the "Safety instructions for the use in explosive atmospheres" (see SIFLUXUS document).