Flexim FLUXUS WW - Serial Interface

FLUXUS WW 8 Connection
64 UMFLUXUS_WWV1-1EN, 2018-02-28
8.4 Serial interface
8.4.1 RS232 interface
The RS232 interface is located on the front plate of the transmitter (see Fig. 8.15).
• Connect the RS232 cable to the transmitter and the serial interface of the PC. If the RS232 cable cannot be connected to
the PC, use the RS232/USB adapter.
The RS232 cable and the RS232/USB adapter are part of the serial data kit (optional).
8.4.2 RS485 interface
The transmitter can also be equipped with an RS485 interface (optional).
For the connection of the RS485 cable to the transmitter, see box "Cable connection" p. 62, Fig. 8.1 and Tab. 8.11) .
For further information on the data transmission, see chapter 13.
Attention! Observe the "Safety instructions for the use in explosive atmospheres" (see SIFLUXUS document).
Note! If a problem occurs when using the RS232/USB adapter for connection, contact your system admin-
istrator.
Fig. 8.15: Transmitter FLUXUS WW
AVSAV
AGN
ARS
AR
BVSBV
BGN
BRS
BR
SA1
SA2
SA3
SA4
SB1
SB2
SB3
SB4
T1a
T1b
S2 T2a
T3a
T3b
S4
T4a
T2b
T4b
T1A
T1B
S1 T2A
T3A
T3B
S3
T4A
T2B
T4B
A+
B-
P1+ P2+
P4+
P5a
P6a P7a
P3+
101
103
P1- P2-
P4-
P5b
P6b
P7b
P3-
PE
N(-)
L(+)
cable gland
cap nut
compression part basic part
serial interface
RS485 (optional)
serial interface
RS232