13 Data logger and transmission of data FLUXUS WW
UMFLUXUS_WWV1-1EN, 2018-02-28 97
13.2.5 Online transmission of data to a terminal program or SD card
• Start the terminal program.
• Enter the transmission parameters into the terminal program (see section 13.2.4). The transmission parameters of the
terminal program and the transmitter have to be identical.
Transmitter settings
• Select the program branch Output Options. Press ENTER.
• Select the channel for which the online transmission is to be activated. Press ENTER until the menu item Serial Out-
put is displayed.
• Set the storage rate (see section 13.1.2).
• Start the measurement. The measuring point number will be requested (see section 13.1.4).
If the transmitter is equipped with an SD card (optional), the measurement data will be stored daily at 00:00 in an ASCII file
(file name: jjmmtt01.txt).
13.2.6 Offline transmission of data to a terminal program
• Start the terminal program.
• Enter the transmission parameters into the terminal program (see section 13.2.4). The transmission parameters of the
terminal program and the transmitter have to be identical.
Select yes to activate the online transmission. Press ENTER.
The measured values are transmitted during the measurement.
Select Special Funct.\Print Meas.Val.. Press ENTER.
This error message will be indicated if no measured valued are stored.
Press ENTER.
This message will be displayed if the measurement values are transmitted.
The progress of the transmission of data is displayed by a bar graph.
This error message will be displayed if an error has oc-curred during the serial transmission.
Press ENTER. Check the connections and make sure the PC is ready to receive data.
Special Funct. ↕
Print Meas.Val.
NO VALUES !
Print Meas.Val.
Send Header 01
................
■ ■ ■ ■ ■ ■
................
SERIAL ERROR !
Print Meas.Val.
To Next Page
Loading...
