Need help?Do you have a question about the Flexim FLUXUS F60 Series and is the answer not in the manual?
General| Fluid Types | Liquids, Gases |
|---|---|
| Outputs | 4-20 mA, pulse, frequency, relay |
| Pipe Diameter Range | 6 mm - 6500 mm (depending on transducer) |
| Flow Velocity Range | 0.01 to 25 m/s |
| Repeatability | 0.15% |
| Temperature Range | -40°C to 200°C (depending on transducer) |
| Power Supply | 100-240 VAC, 50-60 Hz or 24 VDC |
| Communication Interfaces | Modbus |
| Display | LCD |
| Measurement Principle | Ultrasonic transit-time difference |
General guidelines for safe handling and operation of the device.
Safety precautions for electrical connections and work.
Design and components of the transmitter unit.
Key steps for preparing transducer installation, including measuring point selection.
How to connect the transducers to the transmitter for FLUXUS *601.
Details about different transmitter output types and their circuits.
Initial configuration steps for the transmitter (language, units, time/date).
Steps to reset transmitter settings to factory defaults.
Entering pipe, fluid, and transducer parameters for measurement.
Steps to initiate a measurement, including channel activation.
Troubleshooting steps for measurement failures or lack of signal.
Factors affecting the choice of optimal measuring points.
Functions for activating, deactivating, and displaying totalizers.
Configuring binary outputs to function as alarm outputs.
Configuring measurement parameters like NoiseTrek and flow velocity.
Overview of parameter records for storing measurement tasks.
Performing the actual wall thickness measurement.
Formula and explanation for calculating heat flow.
Using BTU mode for heat flow measurement with specific application assignments.
To Next Page