2 Safety instructions
2.3 Not intended use FLUXUS F60*
2017-10-16, UMFLUXUSF60xV5-0EN
10
2.3 Not intended use
Not intended use in terms of a misuse means:
• any work on the measuring equipment without observing all instructions in this operat-
ing instruction
• use of transmitter, transducer and accessories combinations not intended by FLEXIM
• installation of the transmitter, transducers and accessories in explosive atmospheres
they are not approved for
• any work on the measuring equipment (e.g., installation, dismounting, connection, start-
up, operation, service and maintenance) carried out by unauthorized and untrained per-
sonnel
• storage, installation and operation of the measuring equipment outside the specified
ambient conditions, see Technical specification
2.4 Safety instructions for the user
Any work on the transmitter has to be carried out by authorized and qualified personnel.
Observe the safety instructions in the operating instruction. For the technical data of the
transmitter, transducers and accessories, see Technical specification.
• Observe the safety and accident prevention regulations applicable on the site of opera-
tion.
• Only use the supplied mounting fixtures and transducers as well as the intended acces-
sories.
• Always wear the required personal protective equipment.
2.5 Safety instructions for the operator
• The operator shall qualify the personnel to perform their assigned tasks. They shall pro-
vide the required personal protective equipment and oblige the personnel to wear it. It is
recommended to risk assess the workplace.
• Besides the safety instructions in this operating instruction, the health, safety and envi-
ronment regulations applicable for the range of application of the transmitter, transduc-
ers and accessories have to be observed.
• With the exceptions stated in chapter 10, the measuring equipment is maintenance-
free. Any components and spare parts may only be replaced by FLEXIM. The operator
shall carry out periodic checks for changes or damages that can present a danger. For
further information, contact FLEXIM.
• Observe the specifications for the installation and connection of the transmitter, trans-
ducers and accessories, see chapter 6 and 7.
To Next Page
Loading...
Need help?
General
