Flexim FLUXUS F60 Series - Manual Reset of the Totalizers; Display of the Totalizer Sum

18 SuperUser mode
FLUXUS F60* 18.9 Manual reset of the totalizers
183
UMFLUXUS_F60xV5-0EN, 2017-10-16
18.9 Manual reset of the totalizers
If the manual reset of the totalizers is activated, the totalizers can be reset to zero during
the measurement by pressing key C 3 times.
• Select Special Funct.\SYSTEM settings\Measuring\Miscellaneous.
• Press ENTER until the menu item 3xC clear totals is displayed.
• Select on to activate the manual reset of the totalizers, off to deactivate it.
• Press ENTER.
18.10 Display of the totalizer sum
The totalizer sum of both flow directions can be displayed in the upper line during the
measurement.
• Select Special Funct.\SYSTEM settings\Measuring\Miscellaneous.
• Press ENTER until the menu item Show ΣQ is displayed.
• Select on to activate the display of the totalizer sum, off to deactivate it.
• Press ENTER.
If the display of the totalizer sum is activated, the sum ΣQ of the totalizers can be dis-
played in the upper line during the measurement.
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\3xC
clear totals
Notice!
The manual reset of the totalizers is still active after the deactivation of the SuperUser
mode.
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\Show ΣQ
Fig. 18.2: Display of the totalizer sum
ΣQ 13.2 m3