Need help?Do you have a question about the Flexim FLUXUS G608 and is the answer not in the manual?
General| Protection Class | IP 65 |
|---|---|
| Fluid Types | Liquids, gases |
| Measurement Principle | Ultrasonic |
| Accuracy | ±1% of reading |
| Repeatability | 0.15% of measured value |
| Power Supply | 24 V DC |
| Display | LCD |
| Outputs | 4-20 mA |
| Communication | HART, Modbus RTU |
| Temperature Range | -40°C to +200°C |
Instructions for safe operation and to avoid damage or destruction of the flowmeter.
Care instructions for the precision instrument to ensure good results and prevent damage.
Describes the calculation of volumetric flow rate using transit time difference correlation principle.
Importance of selecting measuring points away from flow disturbances for accurate measurement.
Guidance on selecting points considering both flow profile development and noise influence.
Step-by-step guide for connecting transducer cables to the transmitter sockets.
Details on operating the transmitter with the internal battery or external power supply unit.
Step-by-step guide to connect transducer cables to the G608 transmitter.
Details on operating the transmitter using the battery or power cable and adapter.
Guidance on mounting transducers with correct orientation and cable direction.
Guide to entering pipe diameter, wall thickness, material, lining, and roughness.
Instructions for entering medium properties like sound speed, viscosity, density, and temperature.
Recommended transducer distance and how to adjust it for optimal measurement.
Enables measurement of flows with high dynamics by adapting measuring conditions.
Overview of data stored by the logger and activation/deactivation procedures.
How to transmit data online or offline via the serial interface using PC software.
Procedures for enabling and disabling the SuperUser mode using HotCode.
Setting profile bounds for laminar and turbulent flow based on Reynolds numbers.
Connecting the probe and activating the automatic measurement mode.
Steps for measuring wall thickness and sound speed, including applying coupling compound.
Configuring binary outputs as alarms based on switching conditions and holding behavior.
Addresses issues like no signal received, invalid values, and loss of signal during measurement.
Explains causes for large deviations like wrong sound speed, limits, or pipe roughness.
To Next Page