15 Working with Parameter Records FLUXUS G60x
UMFLUXUS_G6V4-2EN, 2011-03-29 111
15 Working with Parameter Records
15.1 Introduction
Parameter records are data sets that contain all information necessary to perform a cer-
tain measurement task:
• pipe parameters
• transducer parameters
• medium parameters
• output options
Working with parameter records will make repeated measurement tasks easier and fast-
er. The transmitter can store max. 14 parameter records.
15.2 Storing of a Parameter Record
The parameters must first be entered in the program branch Parameter. Afterwards,
they can be stored as a parameter record.
15.3 Loading of a Parameter Record
Stored parameter records can be loaded and used for measurement.
Note! No parameter records are stored in the delivery state. Parameter re-
cords are entered manually.
Select Special Funct.\Store Curr.Rec.. Press
ENTER.
This error message will be displayed if no complete pa-
rameter record is available. Storing is impossible. Enter
the missing parameters in the program branch Parame-
ter.
14 parameter records (Par.Record 01...Par.Record
14) can be stored. Select a parameter record. Press EN-
TER.
If parameters are already stored in the selected parameter
record, they can be overwritten.
Select yes to overwrite the parameters, or no to select an-
other parameter record. Press ENTER.
Select program branch Parameter. Press ENTER.
Special Funct. ↕
Store Curr.Rec.
Store Par. To: ↕
Par.Record 01
>PAR<mea opt sf
Parameter
To Next Page
Loading...
Need help?
General
