Flexim FLUXUS G608 - Setting the Contrast; Instrument Information

128 UMFLUXUS_G6V4-2EN, 2011-03-29
FLUXUS G60x 17 Settings
17.5 Setting the Contrast
17.6 Instrument Information
Select Special Funct.\SYSTEM settings\ Mis-
cellaneous to set the contrast of the display of the trans-
mitter. Press ENTER.
The contrast of the display is adjusted with the following
keys:
to increase the contrast
to decrease the contrast
= min. contrast
= medium contrast
= max. contrast
Note!
After a cold start, the display will be reset to medium contrast.
Select Special Funct.\Instrum. Inform. to dis-
play information about the transmitter. Press ENTER.
The type and the serial number of the transmitter will be
displayed in the upper line.
The max. available data logger memory will be displayed
in the lower line (here: 18 327 additional measured values
can be stored). For further information on the data logger
see section 14.1.6.
Press ENTER.
The type and the serial number of the transmitter will be
displayed in the upper line.
The firmware version of the transmitter with date is dis-
played in the lower line.
Press ENTER.
SYSTEM settings ↕
Miscellaneous
SETUP DISPLAY
 CONTRAST 
+ O
-
O
OFF
O
ON
O
Special Funct. ↕
Instrum. Inform.
G60X-XXXXXXXX
Free: 18327
G60X-XXXXXXXX
V x.xx dd.mm.yy