Flexim FLUXUS G608 - Hotcodes

10 Start-up
69
10.2.3 Navigation
10.3 HotCodes
A HotCode is a key sequence used to activate certain settings:
• language selection (see section 10.4)
• activation of the FastFood mode (see section 13.7)
• manual input of the lower limit of the inner pipe diameter (see section 13.9)
• activation the SuperUser mode (see section 18)
• change of the transmission parameters of the RS232 interface (see section 14.2.4)
A HotCode can only be entered in the main menu immediately after the transmitter has
been switched on. The HotCode will not be displayed during the input.
A vertical arrow ↕ will be displayed if the menu item contains a scroll list. The current list
item will be displayed in the lower line.
Use key and to select a list item in the lower line.
Press ENTER.
Some menu items contain a horizontal scroll list in the lower line. The selected list item is
displayed in capital letters between arrows.
Press key and to scroll through the lower line
and select a list item. Press ENTER.
Some menu items contain a horizontal scroll list in the upper line. The selected list item is
displayed in capital letters between arrows. The current value of the list item is displayed
in the lower line.
Press key and to scroll through the upper line
and select a list item.
Press key and to scroll through the lower line and
select a value for the selected list item.
Press ENTER.
Parameter ↕
for Channel A:
ON
O
OFF
O
Lining
no >YES<
-
O
+
O
R1=FUNC<typ mode
Function: MAX
-
O
+
O
ON
O
OFF
O