Need help?Do you have a question about the Flexim FLUXUS G801 and is the answer not in the manual?
General| Fluid Types | Liquids and Gases |
|---|---|
| Measurement Range | 0.01 to 25 m/s |
| Flow Meter Type | Clamp-on Ultrasonic Flow Meter |
| Number of Channels | 1 |
| Pipe Size Range (Liquids) | DN 15 to DN 6500 |
| Pipe Size Range (Gases) | DN 15 to DN 6500 |
| Pipe Diameter Range | 6 to 6500 mm |
| Power Supply | 100 - 240 V AC, 50 - 60 Hz |
| Display | Graphical LCD |
| Data Logging | Internal memory for data storage |
| Communication Interfaces | USB, Ethernet |
| Outputs | 4-20 mA, pulse, frequency, relay |
Covers user, operator, and electrical work safety protocols.
Explains the transit time difference correlation principle for flow velocity measurement.
Steps for wall or pipe mounting of the transmitter.
Selecting measuring point, preparing pipe, and choosing measurement arrangement.
Installation of transducer and pipe damping mats for improved acoustic contact.
Steps for installing transducers, including orientation, arrangement, and fixture types.
Connecting transducers to the transmitter via cable glands.
Connecting the power cable to the transmitter, ensuring proper fitting and tight fit.
Details on connecting analog, binary, and frequency outputs.
Configuring language, units of measurement, and date/time upon first startup.
Entering pipe, fluid, and other parameters crucial for accurate measurement.
Selecting physical quantities, units, and configuring measurement parameters.
Procedures for starting, stopping, and adjusting measurements.
Addressing issues like no signal, invalid values, and signal loss.
Guidance on calibration necessity and checking O-rings for integrity.
Ensuring integrity of housing, sight glass, and flameproof thread gap.
Steps to install and activate binary outputs for alarm or pulse functions.
Configuring frequency outputs to send pulses based on volumetric flow rate.
Applying profile correction and using calculation channels for advanced analysis.
Setting up binary outputs as alarms with properties, limits, and hysteresis.
Defining flow parameters like profile bounds and velocity correction.
To Next Page
