8 Start-up
8.6 Initialization FLUXUS G801
2020-06-26, UMFLUXUS_G801V1-0EN
80
8.6 Initialization
During an initialization (INIT) of the transmitter, the settings in the program branches Parameter and Output Options
and some of the settings in the program branch Special Funct. are reset to the default settings of the manufacturer.
Proceed as follows to execute an initialization:
• When switching on the transmitter: keep BRK and CLR pressed.
• During the operation of the transmitter: press BRK, CLR and ENTER at the same time. A reset is executed. Release only
ENTER. Keep BRK and CLR pressed.
After the initialization has been executed, the message INITIALISATION DONE is displayed.
After the initialization, the remaining settings of the transmitter can be reset to the default settings and/or the stored
measured values can be deleted.
• Select yes to reset the remaining settings of the transmitter to default settings, or no to keep them at the current settings.
• Press ENTER.
If yes is selected, the message FACTORY DEFAULT DONE will be displayed.
• Select yes to delete the stored measured values, or no to keep them.
• Press ENTER.
This display will only be indicated if measured values are stored in the transmitter.
8.7 Date and time
The transmitter has a battery-powered clock. Measured values are automatically stored with date and time.
• Select the menu item Set Clock.
• Press ENTER.
The current time is displayed.
• Select ok to confirm the time, or new to adjust it.
• Press ENTER.
• Select the character to be edited with .
• Edit the selected character with .
• Press ENTER.
The new time is displayed.
• Select ok to confirm the time, or new to adjust it again.
• Press ENTER.
After the time has been set, the date is displayed.
• Select ok to confirm the date, or new to adjust it.
• Press ENTER.
• Select the character to be edited with .
• Edit the selected character with .
• Press ENTER.
The new date is displayed.
• Select ok to confirm the date, or new to adjust it again.
• Press ENTER.
FACTORY DEFAULT
Delete Meas.Val.
Special Funct.\SYSTEM settings\Set Clock\TIME
Special Funct.\SYSTEM settings\Set Clock\DATE
To Next Page
Loading...
