Flexim FLUXUS G801 - Number of Decimal Places of the Totalizers; Manual Reset of the Totalizers

17 SuperUser mode
17.7 Number of decimal places of the totalizers FLUXUS G801
2020-06-26, UMFLUXUS_G801V1-0EN
150
17.7 Number of decimal places of the totalizers
The totalizer values can be displayed with up to 11 places, e.g., 74890046.03. In the SuperUser mode, it is possible to
define the number of decimal places.
• Select the menu item Special Funct.\SYSTEM settings\Measuring\Miscellaneous.
• Press ENTER until the menu item Total digits is displayed.
• Select one of the following list items:
– Automatic: dynamic adaptation
– Fixed to x digit: x decimal places (range: 0...4)
• Press ENTER.
Total digits = Automatic
The number of decimal places will be adjusted dynamically. Low totalizer values will initially be displayed with 3 decimal
places. If the totalizer values are higher, the number of decimal places will be reduced.
Total digits = Fixed to x digit
The number of decimal places is constant. The higher it is, the more the max. value of the totalizers is reduced.
17.8 Manual reset of the totalizers
If the manual reset of the totalizers is activated, the totalizers can be reset to zero during the measurement by pressing
CLR 3 times, even if a program code is activated.
• Select the menu item Miscellaneous.
• Press ENTER until the menu item 3xC clear totals is displayed.
• Select on to activate the manual reset of the totalizers, or off to deactivate it.
• Press ENTER.
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\Total digits
max. value display
< 10
6
±0.000 … ±999999.999
< 10
7
±1000000.00 … ±9999999.99
< 10
8
±10000000.0 … ±99999999.9
< 10
10
±1000000000 … ±9999999999
decimal places max. value max. display
0 < 10
10
±9999999999
1 < 10
8
±99999999.9
2 < 10
7
±9999999.99
3 < 10
6
±999999.999
4 < 10
5
±99999.9999
Notice!
The number of decimal places and the max. value defined here only affect the display of the totalizers.
Special Funct.\SYSTEM settings\Measuring\Miscellaneous\3xC clear totals
Notice!
The manual reset of the totalizers remains activated after the deactivation of the SuperUser mode.