7 Connection
FLUXUS G801 7.3 Outputs
71
UMFLUXUS_G801V1-0EN, 2020-06-26
7.2.1 Cable connection
• Remove the blind plug to connect the cable to the transmitter.
• Prepare the cable with an M20 cable gland. The used cable has to have a wire cross-section of 0.25…2.5 mm².
• Push the cable through the cap nut, compression part and basic part of the cable gland.
• Insert the cable into the housing of the transmitter.
• Screw the sealing ring side of the basic part into the transmitter housing.
• Fix the cable gland by screwing the cap nut onto the basic part.
• Connect the cable to the terminals of the transmitter.
7.3 Outputs
• Connect the output cable to the transmitter (see section 7.2.1, Fig. 7.14 and Tab. 7.9).
Fig. 7.13: Cable gland
1 – cap nut
2 – compression part
3 – basic part
Important!
The max. permissible voltage between the outputs and against PE is 60 V DC (permanent).
Fig. 7.14: Connection of the outputs to the transmitter
FLUXUS *801**-A10****-AA, *801**-A10****-AP
21 3
To Next Page
Loading...
