6 Installation of FLUXUS G601 FLUXUS G60x
UMFLUXUS_G6V4-2EN, 2011-03-29 33
6.4 Power Supply
The transmitter can be operated with the battery (see section 6.4.1) or with the power
supply unit (see section 6.4.2).
6.4.1 Operation with the Battery
The transmitter has a Li-Ion battery and can be operated independently of the power
supply unit.
At delivery, the battery is charged approx. 30 %. The battery does not need to be fully
charged before it is used for the first time.
The charge state of the battery can be displayed during the measurement (see section
10.3) and in the program branch Special Funct.:
This message will be displayed if the battery is almost empty:
Charging the Battery
Connect the power supply unit to the transmitter (see Fig. 6.7). Switch on the transmitter.
The charging starts automatically. The LED "BATTERY" flashes green while charging.
The max. charging time is approx. 5 h.
During the charging process, the ambient temperature should be in the range 0...60 °C.
A measurement can be made during the charging. Charging will be stopped automatical-
ly when the battery is fully charged. The LED "BATTERY" will light green.
Select Special Funct.\Battery status. Press
ENTER.
The current charge state of the battery is displayed
(here: 30 %).
The minus sign "-" indicates that the transmitter is in
battery mode and is being discharged.
The number of cycles the battery has passed is dis-
played after Cy:.
A cycle corresponds to a charging and discharging pro-
cess. The life time of the battery can be derived by
means of this value.
If RELEARN is displayed in the lower line and a question
mark "?" is displayed in front of the current charge state,
a relearn cycle should be started (see section Mainte-
nance on the following page).
The capacity is sufficient for the display and storing of
the current parameter record. A measurement is not
possible anymore.
Special Funct. ↕
Battery status
To Next Page
Loading...
Need help?
General
