2 Handling FLUXUS G60x
UMFLUXUS_G6V4-2EN, 2011-03-29 13
2Handling
2.1 First Inspection
The flowmeter has already been tested thoroughly at the factory. At delivery, proceed to
a visual control to make sure that no damage has occurred during transportation.
Check that the specifications of the flowmeter delivered correspond to the specifications
given on the purchase order.
The type and the serial number of the transmitter are shown on the nameplate. The
transducer type is printed on the transducers.
2.2 General Precautions
FLUXUS is a precision measuring instrument and must be handled with care. To obtain
good measurement results and not damage the instrument, it is important that great at-
tention is paid to the instructions given in this user manual, particularly to the following
points:
• Protect the transmitter from shocks.
• Keep the transducers clean. Manipulate the transducer cables with caution. Avoid ex-
cessive cable bend.
• Make sure to work under correct ambient and operating temperatures. The ambient
temperature must be within the operating temperature range of the transmitter and the
transducers (see annex B, section Technical Data).
• Use a correct external power supply when the transmitter is not used with the battery.
• Handle the battery charging unit and the battery correctly (see section 6.4 or 7.4).
• The power supply unit and the battery charging unit are not protected against moisture.
Use them in dry rooms only.
• Observe the degree of protection (see annex B, section Technical Data).
2.3 Cleaning
• Clean the transmitter with a soft cloth. Do not use detergents.
• Remove traces of the coupling compound from the transducers with a soft paper towel.
Attention! Observe the Safety Instructions for the Use in Explosive Atmo-
sphere (see document SIFLUXUS_608).
To Next Page
Loading...
Need help?
General
