Flexim FLUXUS F60 Series User Manual

18 SuperUser mode
FLUXUS F60* 18.2 Transducer parameters
175
UMFLUXUS_F60xV5-0EN, 2017-10-16
18.2 Transducer parameters
In the SuperUser mode, the menu item Transducer Type will be displayed in the pro-
gram branch Parameter at the end of the input even if the transducers are detected by
the transmitter.
• Press ENTER.
or
• Select Special Version to enter the transducer parameters.
• Press ENTER.
•If Special Version is selected, the transducer parameters have to be entered.
The transducer parameters have to be provided by FLEXIM.
• Press ENTER after each input.
18.3 Definition of the flow parameters
In the SuperUser mode, it is possible to define some flow parameters (profile bounds,
correction of the flow velocity) for the specific application or measuring point.
• Select Special Funct.\SYSTEM settings\Measuring\Calibration.
• Press ENTER.
• Select the measuring channel for which the flow parameters are to be defined (here:
Channel A).
• Press ENTER.
Parameter\...\Transducer Type\Q2E-314
Parameter\...\Transducer Type\Special Version
Parameter\...\Transducer Type\Special Version\Transd. Data 1
Special Funct.\SYSTEM settings\Measuring\Calibration
Special Funct.\SYSTEM settings\Measuring\Calibration\for Channel A:

Flexim FLUXUS F60 Series Specifications

General

Brand	Flexim
Model	FLUXUS F60 Series
Category	Measuring Instruments
Language	English