Flexit UNI 2 - Resetting CI60 Alarms and Faults; C1600 Control Panel Overview; C1600 Panel Layout and Indicators

10
5 Overview of CI600 control panel
No. Description
1
*
UP/INCREASE switch
2
BACK/CANCEL/NO switch
3
DOWN/DECREASE switch
4
OK/YES switch
5
HELP switch
6 Display
7
Indication of OPERATION/OK
-Green light
8
Indication of FILTER CHANGE
-Yellow light
9
Indication of ALARM
-Red light
6
7
8
9
1
*
2
3
4 5
*The numbers are used as references in subsequent descriptions
Fig. 22
4.7 Reset
After the filter has been replaced or the cause of the
alarm repaired, the alarm must be reset. This is done by
pressing switch 12.
If the indicator goes out, the action has been carried out
correctly. If the indicator remains on, the fault has not
been repaired correctly.
NB! If thermostat F10 trips, the unit will have to be
opened up and physically reset before resetting on
the panel. If the alarm trips repeatedly, contact the
service company or distributor.
See chapter 1.4 for more
information.