1
Hardware Installation
To install the Flex-5000, you will need to:
Unpack and decide on a location
Physically connect the radio to a power supply, antenna(s), microphone, key, etc. Although not
necessary, you should preferably make all these connections in advance. However, you must at
least connect the FLEX-5000 to a 13.8VDC power supply and connect the IEEE 1394 FireWire
®
1
cable.
Configure the FLEX-5000:
o FLEX-5000C: Set up and configuring the FLEX-5000C's computer.
o FLEX-5000A: Install and configure the FLEX-5000 FireWire
Driver This driver is
required to enable the computer to interface with the FLEX-5000.
[The rest of this page has been left blank intentionally]
1
FireWire and the FireWire logo are registered trademarks of Apple, Inc., under license.
1 2003-2008 FlexRadio Systems
Chapter
1
To Next Page
Loading...
