2
PowerSDR Installation & Setup
Note: Although PowerSDR is already preinstalled on the FLEX-5000C, the
following sections are relevant if you are upgrading to a later version
of PowerSDR. Otherwise, please skip to PowerSDR Setup Wizard
on page 38.
Upgrading From an Earlier Version
We recommend that you leave older versions of PowerSDR installed when upgrading from a previous
version. After reviewing the new version and verifying that your setup works, uninstalling previous
versions is fine (but not necessary). Note that in order to completely remove previous versions you
must manually delete the database file (PowerSDR.mdb) from the application directory (usually
c:\Program Files\FlexRadio Systems\PowerSDR vn.n.n).
PowerSDR Installation
Download PowerSDR v1.14.0 or later from the FlexRadio downloads page at
http://support.flex - radio.com/Downloads.aspx?fr=1 to a directory on your hard drive (we recommend
saving to the Desktop). If you downloaded the zip file, extract its contents. Double click the Setup file
(Setup.exe) to start the installation process. The PowerSDR installation will prompt you to install the
.NET framework version 1.1
1
if it is not installed and it will point you to the appropriate web address for
downloading as seen in Figure 16.
Figure 16: Prompt for .NET Framework
1
Multiple versions of the .NET Framework can reside on your computer side by side.
33 ď›™ 2003-2008 FlexRadio Systems
Chapter
2
To Next Page
Loading...
Need help?
General
