FlexRadio Systems FLEX-5000 Series - Page 137

S E T U P F O R M C H A P T E R 4
RTTY Offset
The RTTY Offset controls add or subtract the offset entered in DIGU and DIGL respectively, from the
VFO frequency before CAT reports it to a third party program.
 Enable Offset VFOA: Check to apply the RTTY Offset to VFOA
 Enable Offset VFOB: Check to apply the RTTY Offset to VFOB
 DIGL/DIGU: Select the offset to be applied when in DIGU and DIGL mode respectively.
Note: This differs from ClickTune Offsets (see page 83), as the ClickTune
Offsets actually change the Front Console VFO frequency, whereas
the RTTY Offset only offsets the frequency reported by CAT.
[The rest of this page has been left blank intentionally]
128  2003-2008 FlexRadio Systems
Figure 129: RTTY Offset