Tail assembly
USER MANUAL
34
Now, glue the tail boom to the fuselage. Start by routing the elevator servo cable
into the fuselage and precisely fit it in place without glue. It is crucial to to align
the tail, ensuring that the horizontal stabilizer is perfectly parallel to the wings.
To assist in this, you can use something to support all the parts on the table.
You can also use small levels to make sure that both the main part of the
fuselage and the tail are horizontal. For gluing the tail boom, I recommend using
5-minute epoxy glue to allow time for proper alignment of these elements.
It’s best to use 5 min epoxy glue.
To Next Page
