Motor Mount
USER MANUAL
38
You can now install the motor.
Prepare the motor mount printed
from PETG. It is designed for the
recommended T-Motor F90 motor
or another with the same screw
spacing. The motor is attached to
the fuselage from the outside using
M3 screw. To begin, secure the M3
threaded insert using a slightly
heated soldering iron. Then, screw
the motor to the mount and slide it
into the fuselage. The motor is
practically level with the wing, and
the designed slight tilt, combined
with the correctly positioned center
of gravity, is appropriate.
However, if you feel the need for
adjustment, you can slightly increase
the motor's tilt by inserting thin
washers under the lower screws,
adding approximately one degree of
tilt. Route the motor cables through
the opening designed in the
fuselage, slightly below. If you feel
that the motor is not holding
securely enough, you can optionally
attach the motor mount to the
fuselage with a small amount of hot
glue. This is optional, but if you have
any doubts, you can do it
To Next Page
