5 –Camera Controller
A6000 and A8500 Series User’s Manual
47
Sets both the gain and offset terms. Uses two NUC
sources. Computes a bad pixel correction.
Retains the current NUC gain terms and updates the offset
terms. Uses a single NUC source. Retains the current bad
pixel (BP) correction.
Use the internal flag as the NUC source. Because the flag
is not temperature controlled, it can only be used for 1-point
and Offset Update NUC functions
Use an external blackbody as the NUC source. Program
will prompt the user to place each source in front of the
camera. NUC source needs to fill the entire field of view.
Set the number of to average when computing NUC
coefficients. “16 frames” is the default value, which works
well for most scenarios. The value can be to be 2, 4, 8, 16,
32, 64, or 128.
After configuring the correction parameters and selecting Next>> the next window allows the user to
set up the parameters used for the Bad Pixel Detection. Once the parameters are set, select Next>>
to continue.
To Next Page
Loading...
Need help?
General
