FLIR DNR516P16 - Step 4: Connect the Monitor; Step 5: Connect the Power Cable to Power the NVR; Step 6: Upgrade Firmware to Latest Version (if Available)

Basic Setup (DNR500 Series)
6
6.4 Step 4: Connect the Monitor
• Connect the included HDMI cable from the HDMI port to the TV or monitor
(recommended).
OR
• Connect a VGA cable (not included) from the VGA port to the monitor.
1. HDMI port.
2. VGA port.
6.5 Step 5: Connect the Power Cable to Power the NVR
• Connect the included AC power cable to the NVR and connect the other end to a power
outlet or surge protector. Then turn the power switch to l to power on the NVR.
At startup, the system performs a basic system check and runs an initial loading sequence.
After a few moments, the system loads a live display view.
6.6 Step 6: Upgrade Firmware to Latest Version (if Available)
If a firmware upgrade is available, you will be asked to install it once the system starts up.
It is required to upgrade your system firmware and client software or mobile apps to the lat-
est version to enable remote connection to the system.
#LX400023; r. 2.0/23328/23328; en-US
10