FLIR i5

11.10 Marking all areas above or below a set temperature
level
General
You can mark all areas above or below a set temperature level.
Procedure
Follow this procedure:
Push the left selection button (Menu).1
Use the navigation pad to select Measurement.2
Push the left selection button (Select).3
Use the navigation pad to select one of the following:
■
Detect above
■
Detect below
4
Push the left selection button (Select).5
To change the temperature level above or below which you want to mark
the areas, use the navigation pad.
6
26 Publ. No. T559382 Rev. a358 – ENGLISH (EN) – June 23, 2009
11 – Using the camera