11.14 Setting the surface properties
General
To measure temperatures accurately, the camera must know what kind of surface
you are measuring.
The easiest way to do this is to set the surface property on the Measure menu. You
can choose between the following surface properties:
■
Matt
■
Semi-matt
■
Semi-glossy
■
Glossy
Procedure
Follow this procedure to set the surface property:
Push the left selection button (Menu).1
Use the navigation pad to go to Measure.2
Push the left selection button (Select). This will display the Measure sub-
menu.
3
On the Measure menu, use the navigation pad to select a surface property.4
Push the left selection button (Select) to confirm the choice and leave the
menu.
5
SEE ALSO
For more precise measurements, see the following sections:
■
Section 11.15 – Changing the emissivity on page 31
■
Section 11.16 – Changing the reflected apparent temperature on page 32
30 Publ. No. T559382 Rev. a358 – ENGLISH (EN) – June 23, 2009
11 – Using the camera
To Next Page
Loading...
Need help?
General
