FLIR LEPTON® Engineering Datasheet
The information contained herein does not contain technology as defined by the EAR, 15 CFR 772, is publicly available,
and therefore, not subject to EAR. NSR (6/14/2018).
Information on this page is subject to change without notice.
Lepton Engineering Datasheet, Document Number: 500-0659-00-09 Rev: 203
22
Figure 9 - Relative Spatial Noise after FFC vs. Number of Integrated Frames ((defaults is 8)
3.3 Gain States
Lepton 2.5 and 3.5 can be configured to operate in a high-gain state (the only available state in other versions of
Lepton) or a low-gain state. The high gain state provides lower NEDT and lower intra-scene range and the low-
gain state provides higher NEDT but achieves higher intra-scene range. Lepton provides three different gain-
selection modes:
• High (default)
• Low
• Automatic
To Next Page
Loading...