Controlling the camera with a JCU-3 remote keypad
The JCU-3 keypad is included in camera
system packs, and is also available to
purchase as a separate accessory.
A JCU-3 keypad enables you to control the
camera from additional locations on your
vessel, separate from any Raymarine®
LightHouse™ multifunction display or
IP-capable device running a web browser.
You can install multiple JCU-3 keypads.
Multiple JCU-3 keypads can control a
single camera; a single JCU-3 keypad can
control multiple cameras in more complex
systems.
Note: A JCU-3 keypad or Raymarine®
LightHouse™ multifunction display is not
required to operate the camera; a web
browser is sufficient.
A JCU-3 keypad enables you to:
• Control the camera:
– Pan* and tilt the camera
– Zoom the video image (digital)
– Return the camera to its “home”
(default) position
– Set the camera “home” position
– Define up to three user-configurable
buttons
– Park & stow the camera
• Adjust the thermal image: Color palette;
scene presets; video polarity.
*M200-Series cameras only
Pan, tilt, and zoom the
thermal image
2
• Use the circular Uni-controller to:
— Tilt the camera up and down, or pan it
left and right (M200 Series only): press
the inner-ring up, down, left, or right.
— Continuously pan the camera: rotate the
outer-ring of the Uni-controller in either
direction; rotate more to increase pan rate.
• Zoom the thermal image in or out with the
‘-’ or ‘+’ buttons.
Adjust the thermal image; work with
user-programmable buttons (UPBs)
3
• NOT USED with M100/M200-Series
cameras.
• Press momentarily to cycle through
four different color palettes.
• Press and hold to toggle the
polarity of the current color palette.
• Press to cycle through four
different scene presets.
• User programmable buttons (UPBs)—
see Installation and operation instructions.
Set the camera “home” position; park
& stow the camera; cycle through
cameras (multi-camera systems only)
1
• Press momentarily to return the
camera to its home position.
• Press and hold to set the current
camera position as the home
position.
• Press and hold to park & stow the
camera. To reactivate: pan, tilt, or
press the home key.
• Press twice to cycle through cameras
(multi-camera systems only).
To Next Page
Loading...
