User Interface Menus
5
• No Measurements: Select this mode if you do not wish to see any meas-
urement values or icons on the display. Only the camera image will be seen
in this mode.
Figure 5.12 Selecting the ‘No Measurement’ mode from the main menu
• Center Spot (cross-hairs): Enable this mode to view the temperature
measurement of the targeted spot in the upper left hand corner of the dis-
play. Use the cross-hairs to target the measurement spot.
Figure 5.13 Selecting the ‘Center Spot’ mode from the main menu
• IGM™ Moisture mode: Select this mode to view the moisture measure-
ments on the upper left hand corner of the display. The IGM™ mode (Infra-
red Guided Measurement) is best suited for first scanning an area for
temperature measurements and then taking moisture measurements in the
strategic areas identified by the temperature measurements.
#NAS100005; r. AG/62027/62027; en-US
13
To Next Page
Loading...
