Moisture Measurement Operation
7
7.9 High Moisture Alarm
1. To access the Alarm mode use the menus (Settings/Radiometry & Mois-
ture Alarm mode). See Section 8.4 for High/Low Radiometry (Tempera-
ture) Alarm mode.
Figure 7.14 Setting the Moisture Alarm
2. Select the ‘Set Moisture Alarm’ mode.
3. Use the navigation arrows and Select button
to set the Alarm to
‘ABOVE’ or ‘OFF’, to set the max. threshold (0% to 100%), and to select
‘No Sound’ or ‘Beep’ for the alarm alert; the visual alert is always active.
Press Select to confirm and press Return
to exit the menu.
4. When the High Alarm is enabled, the main display will show the alarm bell
icon next to the measurement digits. Refer to Section 5.8 Settings menu
for additional information.
5. When the measurement exceeds the threshold, the text for the measure-
ment reading will appear red in color. Note that in the Moisture-only mode,
the larger digits appear in red when the alarm limit is exceeded. See Fig-
ure 7–15 below.
Figure 7.15 Moisture Alarm display examples
#NAS100005; r. AG/62027/62027; en-US
34
To Next Page
Loading...
