FLIR MR277 - Moisture Meter Specifications; Visible Spectrum Camera Specifications

Specifications
14
Thermal image resolution 160(W) x 120(H) pixels
Spectral response
8~14µm
Field of view 71° horizontal x 51° vertical
Thermal Sensitivity < 150mK
Detection Limit Wet area detection @ 32’ (10m): 19.7in
2
(49cm
2
)
Thermal frame update rate 9 Hz
Thermal image palettes
Selectable: Iron, Rainbow, White hot, Black hot,
and Arctic
Minimum focus distance 4” (10 cm)
Laser pointer
Visible light Class II, centered on thermal image;
1.0 mW (max. power) Wavelength: 650 ±20nm
14.3 Moisture Meter Specifications
Internal Pinless Sensor
Measurements
0 to 100 (relative readings)
External Pin-based
Measurements
7% - 30%;
1
Accuracy for 7% ~ 30% range:
(±1.5% MC);
2
30%-100% (Reference Only)
3
Measurement Resolution 0.1
Pinless Measurement Depth 0.75” (1.9 cm) maximum
Pin Moisture Groups Eleven (11) material groups
Response time Pinless mode: 100ms, Pin mode: 750ms
1. Maximum specified range is dependent on the fiber saturation point for specific species. Beyond
this point, the reading can only be used as a relative reference value. For more information on fi-
ber saturation please refer to public document ASTM D7438. Accuracy specification is based on
the analysis in J. Fernández-Golfín et al. Actual real-world accuracy depends on a variety of fac-
tors; For more information, refer to public document ASTM D4444, section 6.
2. Accuracy spec. applies to pin probe moisture measurements taken on wood whose temperature
is 70°F (20°C). Add 0.1% to the accuracy spec. for each °C below 20 or subtract 0.1 for each °C
above 20.
3. See Note 1.
14.4 Visible Spectrum Camera Specifications
Camera resolution
2M pixels
Focus Fixed
Field of view
83°
#NAS100005; r. AG/62027/62027; en-US
50