FLIR MR60 - 7.2 Moisture Meter Specifications

FLIR MR60 USER MANUAL Document Identifier: MR60-en-US_AB
18
7.2 Moisture Meter Specifications
Internal Pinless Sensor Measurements 0 ~ 100 (relative readings)
External Pin-based Measurements Wood groups (1~9): 7% ~ 30%MC* (±1.5% MC*)
30% ~ 100%* (Reference Only)
Construction material groups (10~11): 0 ~ 20% (reference
only)
Measurement Resolution 0.1
Pinless Measurement Depth 0.75” (1.9cm) maximum
Sample rate 10Hz approximately (for pinless and pin modes)
Pin Moisture Groups Nine (9) wood groups; Two (2) construction material groups
Response time Pinless mode: 100ms
Pin mode: 750ms
Notes:
* Maximum specified range is dependent on the fiber saturation point for specific species. Beyond this point, the
reading can only be used as a relative reference value. For more information on fiber saturation please refer to
ASTM D7438. Accuracy specification is based on the analysis in J. Fernández-Golfín et al. Actual real-world
accuracy depends on a variety of factors; For more information, refer to ASTM D4444, section 6.
**Accuracy spec. applies to pin probe moisture measurements taken on wood whose temperature is 20°C
(68°F). Add 0.1% to the accuracy spec. for each °C below 20°C or subtract 0.1% for each °C above 20°C.