button for 2 seconds to enter View data mode.
The
indicator flashes, and the data stored in that location is
displayed.
2. Press the
or button to step through the memory locations.
3. Press the
, , or button to display the stored data for the
different modes.
4. Press and hold the
button for 2 seconds until a single beep sounds to
exit View data mode.
5.8.4 Clearing the data from memory
Note
To avoid deleting valuable data when done viewing your data, advance the
memory to an empty location before exiting this mode.
1. Press and hold the
button for 2 seconds to enter View data mode.
2. In View data mode, press and hold the
and buttons simultaneously
for 3 seconds to clear all data.
5.9 Alarm settings
High and low alarm thresholds can be set for moisture and humidity measure-
ments. If either of the thresholds is exceeded during the measurement, the meter
beeps and the corresponding alarm indicator is displayed: the low alarm indicator
or the high alarm indicator .
The default setting for the moisture and humidity alarms is off.
To Next Page
Loading...
