5 Operation
1. To enter the alarm set mode, do one of the following:
• To enter the Moisture alarm set mode, press and hold the
button
for 2 seconds.
• To enter the Humidity alarm set mode, press and hold the
button
for 2 seconds.
The current high threshold or OFF (if the alarm is disabled) is flashing on the
main display.
2. To switch from OFF to the numerical display, momentarily press both the
and buttons simultaneously.
3. Use the
and buttons to adjust the high alarm threshold.
4. To disable the high alarm, simultaneously press the
and buttons.
5. When the desired high alarm threshold (or OFF) is displayed, press the
button to save the value.
The current low threshold or OFF (if the alarm is disabled) is now flashing on
the main display.
6. To switch from OFF to the numerical display, simultaneously press the
and buttons.
7. Use the
and buttons to adjust the low alarm threshold. The low
alarm value cannot exceed the high alarm value.
8. To disable the low alarm, simultaneously press the
and buttons.
9. When the desired low alarm threshold (or OFF) is displayed, press the
button to save the value and exit the alarm set mode.
5.10 Locked mode
In Locked mode, the meter ignores all button presses except
and .
The auto power off function, see section 5.1.1 Auto power off, page 12, is dis-
abled in Locked mode.
To Next Page
Loading...
