Flo CoRe+ Series - Step 3: Pedestal and Station Installation

CoRe+
TM
Installation Guide
15
Pedestal and charging station
installation:
• Slide the pedestal over the assembly, making
sure that the terminal blocks are facing the
access door at the bottom of the pedestal,
then tighten the 4 mounting nuts that secure
everything to the anchor.
• Unscrew and remove the plates from the
pedestal.
• Pass the power supply wires (2 lines and 2
ground connectors) from each rectangular
hole at the top of the pedestal down to the
terminal blocks.
• Connect the wires feeding the charging
stations to their respective breakers and install
each charging station on the pedestal, as per
the CoRe+ Installation Guide.
Installation Guide
Cascading on a 40 A Circuit
STEP 3