CoRe+
TM
Installation Guide
4
Introduction
IC Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3 (A) / NMB-3 (A)
FCC Notice (for USA only)
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any
interference received, including interference that may cause undesired operation.
Exposure to Radio Frequency Energy: The radiated power output of the communication modules
included in this device is below the limits recommended for the general population for uncontrolled
exposure as defined in the FCC standards. This device should be operated with a minimum distance
of at least 200 mm (7.87'') between itself and a person’s body and must not be colocated or operated
with any other antenna in order to comply the conditions of the FCC Grants.
Modifications not expressly approved by FLO and AddÉnergie Technologies inc. could void the user’s
authority to operate the equipment.
To Next Page
Loading...
