Torque nuts to specification, not bolts.
Place parts and fasteners in designated locations prior to each step.
Before tightening fasteners to specified torque, ensure that the lift is square.
Measure from corner to corner (A to C/B to D) to verify that the lift is square.
Measure distance between corner posts (A to B, B to C, C to D, A to D) above frame beam and at the
top of the corner post to verify that the lift is square.
Ensure that the lift is level and square before proceeding to install the V-Brace or Ball Screw Tube.
Assemble cradle clamps with given bolt and nut before installing onto cradle beam.
Use a marker to denote fasteners which have been tightened to the specified torque.
Read instructions and understand them before attempting assembly.
To Next Page
Loading...
