MAINTENANCE /
REPAIR
OPERATION /
CALIBRATION
ASSEMBLY /
INSTALLATION
GETTING STARTED
4
SAFETY /
SPECIFICATIONS
GENERAL SAFETY INSTRUCTIONS
IMPORTANT: It is your responsibility to:
• Ensure that all equipment operators have access to adequate
instructions concerning safe operating and maintenance
procedures.
Compatibility of this product’s material and the process fluid
and/or environment should be considered prior to putting into
service.
Product should never be operated outside its published
specifications for temperature or pressure. See specifications for
your model.
Make sure flow and pressure have been eliminated from process
pipe prior to installing or removing product.
Always use appropriate thread sealant or flange gaskets when
connecting product to process piping.
To protect against leakage, seal all pipe threads with an
appropriate sealing compound. Make sure the sealing compound
does not intrude into the flow path.
NOTE: If connecting to new male pipe threads, burrs and curls
can adversely affect accuracy. Correct the problem prior to turbine
installation.
Installation near high electromagnetic fields and high current
fields is not recommended and may result in inaccurate
readings.
To Next Page
Loading...
Need help?
General
