Flomec TM Series - Incorrect Flowrate Display; Incorrect Volume Totals Display

13
TROUBLE SHOOTING (Continued)
E. Q9 display value
not giving correct
Flowrate.
1. Q9 display showing velocity or
volume totals instead of
flowrate.
2. Q9 display calibration is not
optimized for best results.
1. Press "top button" of Q9
display until flowrate is
displayed (see Operation
Section in Q9 owner's
manual).
2. If "1" above is not the
Issue, See
Operation/Calibration
Section of this manual
F. Q9 display value
not giving correct
volume totals.
1. Q9 display showing velocity,
flowrate, or accumulative total
instead of batch total.
2. Q9 display calibration is not
optimized for best results.
1. Press "bottom button" of
Q9 display until correct
volume is displayed (see
Operation Section in Q9
owner's manual).
2. If "1" above is not the
Issue, see
Operation/Calibration
Section of this manual.